WF-R8590_R8591_R8593_RevF

Publish in

Documents

72 views

Please download to get full document.

View again

of 332
All materials on our website are shared by users. If you have any questions about copyright issues, please report us to resolve them. We are always happy to assist you.
Share
Description
epson WF-R8590_R8591_R8593_RevF.pdf service manual
Tags
Transcript
  SERVICE MANUAL CONFIDENTIAL  RevisionE Color Ink jet Printer EPSON WF-R8590 EPSON WF-R8591 EPSON WF-R8593 SEMF14-006  Confidential Notice:  All rights reserved. No part of this manual may be reproduced, stored in a retrieval system, or transmitted in any form or  by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION.  All effort have been made to ensure the accuracy of the contents of this manual. However, should any errors be detected, SEIKO EPSON would greatly appreciate being informed of them.  The contents of this manual are subject to change without notice.  The above not withstanding SEIKO EPSON CORPORATION can assume no responsibility for any errors in this manual or the consequences thereof. EPSON is a registered trademark of SEIKO EPSON CORPORATION.  Note:Other product names used herein are for identification purpose only and may be trademarks or registered trademarks of their respective owners. EPSON disclaims any and all rights in those marks. Copyright © 2016 SEIKO EPSON CORPORATIONPrinter CS Quality Assurance Department  Confidential Safety Precautions All safety procedures described here shall be strictly adhered to by all parties servicing and maintaining this  product.  DANGER Strictly observe the following cautions. Failure to comply could result in serious bodily injury or loss of life.1.Always disconnect the product from the power source and peripheral devices when servicing the product or  performing maintenance.2.When performing works described in this manual, do not connect to a power source until instructed to do so. Connecting to a power source causes high voltage in the power supply unit and some electronic components even if the product power switch is off. If you need to perform the work with the power cable connected to a  power source, use extreme caution to avoid electrical shock. WARNING Strictly observe the following cautions. Failure to comply may lead to personal injury or loss of life.1.Always wear protective goggles for disassembly and reassembly to protect your eyes from ink in working. If any ink gets in your eyes, wash your eyes with clean water and consult a doctor immediately.2.When using compressed air products; such as air duster, for cleaning during repair and maintenance, the use of such products containing flammable gas is prohibited.  PRECAUTIONS Strictly observe the following cautions. Failure to comply may lead to personal injury or damage of the product.1.Repairs on Epson product should be performed only by an Epson certified repair technician.2.No work should be performed on this product by persons unfamiliar with basic safety knowledge required for electrician.3.The power rating of this product is indicated on the serial number/rating plate. Never connect this product to the power source whose voltages is different from the rated voltage.4.Replace malfunctioning components only with those components provided or approved by Epson; introduction of second-source ICs or other non-approved components may damage the product and void any applicable Epson warranty.5.In order to protect sensitive microprocessors and circuitry, use static discharge equipment, such as anti-static wrist straps, when accessing internal components.6.Do not tilt this product immediately after initial ink charge, especially after performing the ink charge several times. Doing so may cause ink to leak from the product because it may take some time for the waste ink pads to completely absorb ink wasted due to the ink charge.7.Never touch the ink or wasted ink with bare hands. If ink comes into contact with your skin, wash it off with soap and water immediately. If you have a skin irritation, consult a doctor immediately.  Confidential 8.When disassembling or assembling this product, make sure to wear gloves to avoid injuries from metal parts with sharp edges.9.Use only recommended tools for disassembling, assembling or adjusting the printer.10.Observe the specified torque when tightening screws.11.Be extremely careful not to scratch or contaminate the following parts.   Nozzle plate of the print head  CR Scale  PF Scale  ASF Scale  Coated surface of the PF Roller   Gears  Rollers  LCD  Scanner Sensor   Exterior parts 12.Never use oil or grease other than those specified in this manual. Use of different types of oil or grease may damage the component or give bad influence on the printer function.13.Apply the specified amount of grease described in this manual.14.Make the specified adjustments when you disassemble the printer.15.When cleaning this product, follow the procedure described in this manual.16.When transporting this product after filling the ink in the print head, pack the printer without removing the ink pack in order to prevent the print head from drying out. In addition, make sure to secure the CR Unit with tape before packing the printer 5.2 Protection for Transportation (p330) .17.Make sure to install antivirus software in the computers used for the service support activities.18.Keep the virus pattern file of antivirus software up-to-date.
We Need Your Support
Thank you for visiting our website and your interest in our free products and services. We are nonprofit website to share and download documents. To the running of this website, we need your help to support us.

Thanks to everyone for your continued support.

No, Thanks